Davids Shopping Suggestions To Stick To When You Are Looking At Antique Bathroom Sinks

Thinking about upgrading your worn out bathroom plus adding some extra storage at the identical time? Or simply bored with looking at the ancient vanity the builders place in and want something a little more enticing? No matter your reason, putting in a bathroom vanity is a job a competent do it yourselfer can tackle, and it should not shut you out of your bathroom for more than only a day. 

The first thing you need to do is lose the sink or vanity that is already in your bathroom and get the space prepared for your new vanity. Check beneath the vanity to see how it’s attached – possibly with some screws thru a rail on the back (often known as a “nailer”), or in the corners. When your head is underneath the countertop, look to see how your countertop plus sink are connected to the base. Once more there may be screws holding the top in place, or it can simply be held in place with glue.  

Removing your old vanity can be easier if you’re taking off the top (it’ll be lighter). Finally use a utility knife and run the blade around the edge, cutting thru any caulking holding the vanity edges to the walls or backsplash. 

As in any plumbing project, before you begin, turn off the water to your bathroom. Hopefully this means closing the shut off valves on the water feed lines to the vanity, but in several cases it’d mean you need to shut off the water to the full house. You’ll need an adjustable wrench to disconnect the supply tubes from the faucet bases, and a large wrench or slip joint pliers to undo the drain. (It’s an excellent plan to have a bucket handy when you open the drain to catch the water that’s remaining during the trap.)  Learn more about antique bathroom sinks here.

Take off the doors plus take away the drawers from the vanity. If there is any molding round the bottom of the vanity, take away it as well. Now get down on your knees plus take out the screws holding the vanity the wall, plus if you’re going to take off the top, undo the screws holding it in place or use a pry bar to break it away from the base.  

You can be in a position to slip the vanity out and away from the wall, but in some cases you can have to pry it away from the wall. If you do, use a thin scrap of wood to protect the wall from the pry bar. It’s a good idea to put down a thin sheet of plywood or even an old blanket to prevent gouging your floor when sliding the vanity.  

Once you have got removed the old vanity, inspect the space for any damage. This is when you can repair any dings or water harm in the walls and ensure your floor is sound plus level.